Toro 31950 - Installing Rear Wire Harness Bracket

InstallingtheRearWireHarness
Bracket
1.Removethe2angelocknuts(1/2inch),2
capscrews(1/2x4-1/2inches),and2washers
(1/2inch)thatsecurethehitchtubetothe
receiver(Figure7).
g280312
Figure7
1.Capscrew(1/2x4-1/2
inches)
4.Flangelocknut(1/2inch)
2.Washer(1/2inch)
5.Harnessbracket
3.Receivertube
2.Aligntheholesintheharnessbracketwiththe
holesinthereceiverasshowninFigure7.
3.Assembletheharnessbrackettotheclevis
withthe2capscrews,2washers,and2ange
locknutsthatyouremovedinstep1.
4.Torquethelocknutsandcapscrewsto67to83
N∙m(91to113ft-lb).
g280309
Figure8
5