Toro 37798 - Adjusting the Discharge-Chute Latch; Replacing the Drive Belts

g001029
Figure37
1.0.76mm(0.030inch)
5.Installthenewsparkplug,tightenitrmly,and
attachtheignitionwiretothesparkplug.
Note:Ensurethattheignitionwiresnaps
completelyintoplaceonthesparkplug.
Adjustingthe
Discharge-ChuteLatch
Ifthedischargechutedoesnotlockintothedesired
positionordoesnotunlocksothatyoucanmoveitto
anotherposition,adjustthedischarge-chutelatch.
1.Loosentheclampfasteneronthechute-support
plateuntilthecableisfree.
g019021
Figure38
1.Cableconduit3.Clampfastener
2.Cableclamp
2.Removeanyslackinthecablebypullingthe
cableconduitrearward.
3.Tightentheclampfastenerwhileholdingthe
cableinplace.
ReplacingtheDriveBelts
Iftheauger/impellerdrivebeltorthetraction-drivebelt
becomesworn,oil-soaked,orotherwisedamaged,
haveanAuthorizedServiceDealerreplacethebelt.
25