Toro 38282 - Initial Setup Procedures; Loose Parts Verification; Handle Installation Procedure

Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
Oval-headbolts
2
Curvedwashers
2
1
Handleknobs2
Installthehandle.
2
Nopartsrequired
–
Installtherecoilstarterhandle.
Dischargechuteassembly1
Screws
2
Washers2
Locknuts2
3
Knob1
Installthedischargechuteassembly.
4
Bottleofengineoil
1Filltheenginewithoil.
5
Nopartsrequired
–
Adjustthecontrolcable.
1
InstallingtheHandle
Partsneededforthisprocedure:
2
Oval-headbolts
2
Curvedwashers
2Handleknobs
Procedure
1.Positiontheendsoftheupperhandleontheinside
ofthelowerhandleandaligntheholes.
2.Inserttheoval-headboltsintothealignedholes,with
theboltheadsontheoutsideofthehandle(
Figure3).
Figure3
1.Oval-headbolt(2)2.Curvedwashersand
handleknobs
3.Installthecurvedwashersandthehandleknobs
ontheoval-headboltsontheinsideofthehandle
(
Figure3)andtightentheknobssecurely.
Important:Ensurethatthecableisroutedto
theoutsideofthehandle.
5