Toro 38820 - Replacing the Drive Belts; Replacing the Headlight Bulb

Figure51
2.Loosentheboltonthecableclamp(Figure52).
Figure52
1.Cableconduit2.Cableclamp
3.Graspthecableconduitandmoveittowardthefront
ofthemachineuntilthedischargechutelatchfully
engagesthegearteeth(Figure52andFigure53).
Figure53
1.Dischargechutelatch
2.Gearteeth
Note:Thelatchisspringloadedandwillnaturally
moveintotheteethofthegear(Figure53).
4.Removeanyslackinthecablebypullingthecable
conduitrearward.
5.Tightentheboltonthecableclamp,beingcarefulnot
tostriptheplasticpart.
6.Installandsecurethegearcover.
ReplacingtheDriveBelts
Iftheauger/impellerdrivebeltorthetractiondrivebelt
becomesworn,oil-soaked,orotherwisedamaged,havean
AuthorizedServiceDealerreplacethebelt.
ReplacingtheHeadlightBulb
UseaGE89937Whalogenlightbulb.Donottouchthe
bulbwithyourhandsorallowdirtormoisturetocomeinto
contactwiththebulb.
1.Removethewireconnectorfromthebackofthe
headlight(Figure54).
Figure54
2.Turnthebaseofthebulbcounterclockwiseuntilit
stops(Figure55).
Figure55
3.Removethebulbstraightoutfromthebackofthe
headlight(Figure56).
Figure56
4.Insertanewbulbintothebackoftheheadlight(Figure
57).
24