How do I fix a Toro 38812 discharge chute that won't lock or move?
If the discharge chute on your Toro Snow Blower either doesn't lock into place or doesn't move, it might be because the discharge chute latch is not properly adjusted. Adjust the discharge chute latch.
How to fix a Toro 38812 Snow Blower that runs rough?
If your Toro Snow Blower is running rough, consider these potential causes and solutions: * The choke may be in the On position. Move the choke to the Off position. * The fuel shutoff valve may not be completely open. Open the fuel shutoff valve. * The fuel tank may be nearly empty or contains stale fuel. Drain and fill the fuel tank with fresh gasoline (not more than 30 days old). * The spark plug wire may be loose. Connect the wire to the spark plug. * The spark plug may be pitted, fouled, or the gap is incorrect. Check the spark plug and adjust the gap if necessary. Replace the spark plug if it is pitted, fouled, or cracked. * The engine oil level in the engine crankcase may be too low or too high. Add or drain oil to adjust the oil level in the engine crankcase to the Full...
Why does my Toro Snowthrower engine not start?
Your Toro Snowthrower engine may not start due to several reasons: 1. The key might not be in the ignition or is in the Stop position, so insert the key into the ignition and turn it to the On position. 2. The choke might be in the Off position, and the primer has not been pressed, so move the choke to the On position and press the primer 3 times. 3. The fuel shutoff valve might not be open, so open the fuel shutoff valve. 4. The throttle might not be in the Fast position, so move the throttle to the Fast position. 5. The fuel tank might be empty or contain stale fuel, so drain and/or fill the fuel tank with fresh gasoline (not more than 30 days old). 6. The spark plug wire might be loose or disconnected, so connect the wire to the spark plug. 7. The spark plug might be pitted, fou...
Why won't my Toro 38812 start?
Your Toro Snow Blower might not start due to several reasons: * The key may not be in the ignition or is in the Stop position. Insert the key into the ignition and turn it to the On position. * The choke may be in the Off position and the primer has not been pressed. Move the choke to the On position and press the primer 3 times. * The fuel shutoff valve may not be open. Open the fuel shutoff valve. * The throttle may not be in the Fast position. Move the throttle to the Fast position. * The fuel tank may be empty or the fuel system contains stale fuel. Drain and/or fill the fuel tank with fresh gasoline (not more than 30 days old). * The spark plug wire may be loose or disconnected. Connect the wire to the spark plug. * The spark plug may be pitted, fouled, or the gap is i...
What causes the discharge chute on my Toro Snowthrower to not lock or move?
If the discharge chute on your Toro Snowthrower doesn't lock or move, it's likely that the discharge chute latch is not properly adjusted. Adjust the discharge chute latch.
Why is my Toro Snowthrower not clearing snow off the surface properly?
If your Toro Snowthrower isn't clearing snow properly, it could be because: 1. The skids and/or scraper are not properly adjusted, so adjust the skids and/or the scraper. 2. The pressure in the tires is not equal, so check and adjust the pressure in one or both tires.
What to do if the electric starter on my Toro Snowthrower doesn't turn?
If the electric starter on your Toro Snowthrower isn't turning, here's what might be happening: 1. The power cord is disconnected at the outlet or the machine, so connect the power cord to the outlet and/or the machine. 2. The power cord is worn, corroded, or damaged, so replace the power cord. 3. The power outlet is not energized.
What to do if discharge chute does not lock on Toro 38812?
Adjust the discharge chute latch on your Toro Snow Blower to ensure it locks into place and moves correctly.
How to troubleshoot electric starter that does not turn on Toro Snow Blower?
If the electric starter on your Toro Snow Blower isn't turning, first, make sure the power cord is securely connected to both the outlet and the machine. If the cord is damaged, replace it. If the outlet isn't working, have a qualified electrician check it.
Why my Toro 38812 engine does not start?
To address the issue of your Toro Snow Blower not starting or starting with difficulty, verify the key is correctly inserted and in the On position. Ensure the choke is On and the primer is pressed 3 times. Check that the fuel shutoff valve is open and the throttle is in the Fast position. Also, ensure the fuel tank has fresh gasoline, the spark plug wire is connected, and the spark plug is in good condition with the correct gap. Finally, verify the fuel vent cap isn't restricted and the engine oil level is correct.
General| Starting System | Recoil |
|---|---|
| Engine Type | 4-cycle OHV |
| Engine Displacement | 212cc |
| Starter Type | Recoil |
| Speed Settings | 6 Forward, 2 Reverse |
| Chute Control | Quick Lever |
| Engine | 212cc |
| Clearing Depth | 12.5 in (32 cm) |
| Weight | 84 lbs |
| Chute Rotation | 210 degrees |
| Throw Distance | Up to 35 feet |
| Intake Height | 12.5 in (32 cm) |
| Skid Shoes | Adjustable |
| Warranty | 2-Year Full Coverage |
To Next Page
