3. On the engine end of the driveshaft, slide
the front flange over the square key on the
engine crankshaft (A).
Note: On diesel powered tractors, the key is
fitted to the flange (B). Then the flange is slid
into a hub (C) mounted to the crankshaft’s
pulley.
4. Install the four spacers through the rubber
couplings making sure they are properly
seated and squared to the coupling.
Note: The spacers with the tall heads (A)
attach the coupling to the flange on the
transmission.
2.7162.005
2.3653.011
2.3653.014
2
CHASSIS
5xi Series Tractor Service Manual 2-23
To Next Page
Loading...
