Toro 520XI - Bulb Installation; Instrument Panel Lights; Bulb Removal; Bulb Replacement

Bulb Installation
1. Align the pins on the bulb with the slots in
the bulb holder and insert. Push and rotate
the bulb clockwise until it stops.
2. Align the tabs on the bulb holder with the
slots in the reflector, insert and rotate 1/4
turn clockwise until it stops.
3. Push the wire connectors onto the terminals.
Bulb Number: GE 1156
INSTRUMENT PANEL LIGHTS
Bulb Removal
1. Disengage the PTO, set the parking brake,
turn the ignition key to OFF, and remove the
key.
2. Turn the bulb holder 1/4 turn
counterclockwise, and remove it from the
panel
3. Pull the bulb straight out of the bulb holder.
Bulb Number: GE 194
Bulb Replacement
1. Align the bulb with the slot in the bulb holder
and push the bulb into the slot.
2. Align the tabs on the bulb holder with the
slots in the panel. Insert the bulb being
careful not to damage the printed circuit
connectors.
Rotate the bulb approximately 1/4 turn until it
stops.
Bulb Number: GE 194
2.0757.031
2.0144.018
2.0144.024
6
ELECTRICAL
5xi Series Tractor Service Manual 6-7