Toro 58610 - Assembling the Handlebars; Handlebar Assembly Steps

1
AssemblingtheHandlebars
Partsneededforthisprocedure:
1Dashpanelassembly
1Toolholder
1Mountingplate
1Blade-controlhandle
4
Bolt(M6x20mm)
3
Bolt(M8x25mm)
1
Bolt(M8x30mm)
4
Locknut(M6)
4
Nut(M8)
Procedure
1.Installthehandlebarassemblyanddashpanel
assembly.
Note:Ensurethatthethrottlecableroutes
outsideofthehandlebarassembly,notthrough
themiddle.
g383581
Figure3
1.Handlebarassembly3.Dashpanelassembly
2.Bolt—M6x20(2each
side;4total)
4.Locknut—M6(2eachside;
4total)
2.Installthetoolholderandblade-controlhandle.
Note:Usethebolt(M8x30mm)inthelower
leftcorner.
g383593
Figure4
1.Mountingplate4.Toolholder
2.Bolt—M8x25mm(2)
5.Blade-controlhandle
3.Bolt—M8x30mm
6.Nut—M8(4)
7