Toro 58610 - Assemble the Cutting Head; Cutting Head Assembly Steps

2
AssembletheCuttingHead
Partsneededforthisprocedure:
1
Cuttingheadassembly
1Pivotrod
1Bracket
1
Bolt(M8x20mm)
1
Nut(M8)
4Hairpincotter
Procedure
1.Removetheengineshroudcoveringthepulley.
g383691
Figure5
1.Shroud2.Bolt—M5x12mm(2)
2.Installthepivotrodandhairpincotter.
g383689
Figure6
1.Hairpincotter2.Pivotrod
3.Pushthepivotrodasfarleftaspossible.
4.Installthebeltfromthecutterheadontothe
enginepulley.
5.Slidethecutterheadontothepivotrodand
secureittotherodandframe.
Note:Youmaytipthemachineonitsrightside
toaidintheassembly.
g383690
Figure7
1.Nut(M8)4.Bolt(M8x20mm)
2.Cutterhead
5.Hairpincotter
3.Belt
6.Supportracket
6.InstalltheengineshroudasshowninFigure5.
8