Operation
24
Note: For reverse motion, with the PTO
engaged, the operating–in–reverse
interlock must be deactivated by the
“key choice” switch located in front of
and below the seat.
Stopping the Machine
To stop the machine, push the clutch in and shift to
neutral (”N”). Disengage the power take off (PTO),
and turn the ignition key to “OFF” to stop the engine.
Also set the parking brake if you leave the machine
unattended; refer to Setting the Parking Brake,
page 17. Remember to remove the keys from the
ignition and “Key Choice” switches.
POTENTIAL HAZARD
• Someone could move or attempt to operate
the tractor while it is unattended.
WHAT CAN HAPPEN
• Children or bystanders may be injured if
they use the tractor.
HOW TO AVOID THE HAZARD
• Always remove the ignition and “Key
Choice” keys and set the parking brake
when leaving the machine unattended, even
if just for a few minutes.
IMPORTANT: Do not “Ride the Brakes”.
Shift to a lower gear for slower ground speed.
Choose a slow speed so that you will not have
to stop or shift while on a slope.
Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
1. Raise the seat and loosen the lock nuts (Fig. 7).
2. Slide the seat to the desired position and tighten
the lock nuts.
1
Figure 7
1. Lock nuts
To Next Page
Loading...
