Decal 132-0871 is for machines with MyRide only .
decal132-0871
132-0871
Note: This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator ’ s Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in the conditions on
that day and at that site. Changes in the terrain can result in a change in slope operation for the machine.
1. W arning—read the Operator ’ s Manual ; all operators should
be trained before operating the machine; wear hearing
protection.
4. T ipping hazard—do not use dual ramps when loading onto a
trailer; use 1 ramp wide enough for the machine; use a ramp
with a slope less than 15°; back up the ramp (in reverse) and
drive forward of f the ramp.
2. Cutting/dismemberment hazard of hand—stay away from
moving parts; keep all guards and shields in place.
5. Runover hazard—do not carry passengers; look behind you
when moving in reverse.
3. Thrown object hazard—keep bystanders away .
6. T ipping hazard—do not use the machine near drop-of fs or
on slopes greater than 15°; only operate across slopes less
than 15°.
Decal 132-5067 is for machines with MyRide only .
decal132-5067
132-5067
1 1
To Next Page
Loading...
Need help?
General
