Toro 74237 - Positioning the Seat; Unlatching the Seat; Pushing the Machine by Hand

Figure 20
1. Outer roller 4. Bolt
2. Spacer
5. Nut
3. Bushing
4. Select a hole so that the center rollers are
positioned to the nearest cor responding
height-of-cut desired ( Figure 20 ).
Note: Do not adjust the rollers to suppor t
the mo w er housing .
5. Install the center rollers , bushing, spacer , bolt,
and n ut ( Figure 20 ).
6. T or que the bolt to 40 to 45 ft-lb (54 to 61
N ⋅ m).
Positioning the Seat
T he seat can mo v e forw ard and bac kw ard.
P osition the seat where y ou ha v e the best control
of the mac hine and are most comfor table .
Important: T o adjust, mo v e the lev er
sidew ays to unlock seat ( Figur e 21 ).
Slide the seat to the desired position and release
lev er to loc k in position.
Figure 21
1. Adjustment lever
Unlatching the Seat
Push the seat latc h rearw ard to unlatc h the seat.
T his will allo w access to the mac hine under the
seat ( Figure 22 ).
Figure 22
1. Seat latch
3. Seat
2. Fuel cap
Pushing the Machine by
Hand
Important: Al w ays push the machine
by hand. Nev er to w the machine because
h y draulic dama ge may occur .
Pushing the Machine
1. Diseng ag e the po w er tak e off (PTO) and
tur n the ignition k ey to off . Mo v e the lev ers
23