Charging the Battery
Charging the batter y pr oduces gasses that
can explode.
Nev er smok e near the batter y and k eep
spar ks and flames a w ay fr om batter y .
Important: Al w ays k eep the batter y
full y charged (1.265 specific g ra vity). T his
is especiall y impor tant to pr ev ent batter y
dama ge when the temperatur e is belo w 32°F
(0°C).
1. R emo v e the batter y from the c hassis .
2. Charg e batter y for 10 to 15 min utes at 25 to 30
amps or 30 min utes at 4-6 amps .
3. W hen the batter y is fully c harg ed, unplug
the c harg er from the electrical outlet, then
disconnect the c harg er leads from the batter y
posts (Fig . 67).
Figure 38
4. Install the batter y in the mac hine and connect
the batter y cables; refer to Installing the
Batter y .
Note: Do not r un the mac hine with the
batter y disconnected, electrical damag e ma y
occur .
Servicing the Fuses
T he electrical system is protected b y fuses . It
requires no maintenance , ho w ev er , if a fuse blo ws
c hec k component/circuit for malfunction or shor t.
T he fuses are as follo ws:
• Main F1-30 amp , blade-type
• Alter nator F2-25 amp , blade-type
1. Unlatc h the seat and raise the seat to g ain
access to fuse holder ( Figure 39 ).
Figure 39
1. Main F1-30 amp
2. Alternator F2-25 amp
2. T o re place the fuses , pull out on the fuse to
remo v e it.
3. Install a new fuse ( Figure 39 ).
35
To Next Page
Loading...
