Toro 74722 - Page 39

3.Measurefromthetipofthebladetotheatsurface
(Figure45).
G014973
1
2
3
Figure45
1.Blade(inpositionformeasuring)
2.Levelsurface
3.Measureddistancebetweenbladeandthesurface(A)
4.Rotatethesameblade180degreessothattheopposing
cuttingedgeisnowinthesameposition(Figure46).
G014974
1
2
3
Figure46
1.Blade(sidepreviouslymeasured)
2.Measurement(positionusedpreviously)
3.Opposingsideofbladebeingmovedintomeasurement
position
5.Measurefromthetipofthebladetotheatsurface
(Figure47).
Note:Thevarianceshouldbenomorethan3mm
(1/8inch).
G014973
1
2
3
Figure47
1.Oppositebladeedge(inpositionformeasuring)
2.Levelsurface
3.Secondmeasureddistancebetweenbladeandsurface(B)
A.IfthedifferencebetweenAandBisgreaterthan
3mm(1/8inch),replacethebladewithanew
blade;referto(page)andInstallingtheBlades
(page40).
Note:Ifyoureplaceabentbladewithanew
bladeandthedimensionobtainedcontinuesto
exceed3mm(1/8inch),thebladespindlecould
bebent.ContactanAuthorizedToroDealerfor
service.
B.Ifthevarianceiswithinconstraints,movetothe
nextblade.
6.Repeatsteps1through5foreachblade.
39