EasyManua.ls Logo

Toro 74806 TimeCutter ZX525 - Servicing the Air Cleaner

Toro 74806 TimeCutter ZX525
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 23
1. Oil lter 2. Adapter
4. Install the re placement oil filter to the adapter .
T ur n the oil filter cloc kwise until the r ubber
g ask et contacts the filter adapter , then tighten
the filter an additional 3/4 tur n ( Figure 23 ).
5. Fill the crankcase with the proper type of new
oil; refer to Changing and Draining the Oil.
Servicing the Air Cleaner
F oam Element: Clean and oil after ev er y
25 operating hours .
P aper Element: Clean after ev er y 100 operating
hours . R e place after ev er y 200 operating hours or
yearly , whic hev er comes first.
Note: Ser vice the air cleaner more frequently
(ev er y few hours) if operating conditions are
extremely dusty or sandy .
Removing the Foam and Paper
Elements
1. Diseng ag e the PTO and mo v e the control
lev ers to the neutral loc k ed position and apply
the parking brak e .
2. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. Clean around the air cleaner to prev ent dir t
from g etting into the engine and causing
damag e . Unlatc h the tw o side latc hes and
remo v e the air cleaner co v er ( Figure 24 ).
4. Carefully remo v e the foam element from the
paper element ( Figure 24 ).
5. Unscrew the wing n ut and remo v e the paper
element ( Figure 24 ).
Figure 24
1. Cover
4. Wing nut
2. Foam element 5. Air cleaner base
3. Paper element 6. Latches
Cleaning the Foam and Paper
Elements
1. F oam Element
A. W ash the foam element in liquid soap and
w ar m w ater . W hen the element is clean,
rinse it thoroughly .
B . Dr y the element b y squeezing it in a clean
cloth (do not wring). Allo w the element to
air dr y .
C . Soak the element in new engine oil.
( Figure 25 ). Squeeze the element to remo v e
ex cess oil.
Important: R eplace the f oam
element if it is tor n or w or n.
Figure 25
1. Foam element 2. Oil
2. P aper Element
A. Lightly tap the element on a flat surface to
remo v e dust and dir t ( Figure 26 ).
B . Inspect the element for tears , an oily film,
and damag e to the r ubber seal.
24

Table of Contents

Related product manuals