5
Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near any area
of potential danger. Replace any decal that is damaged or lost.
92–7112
Setup
Note: Determine the left and right sides of the machine
from the normal operating position.
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Hitch
Spring bracket
Bolt, 3/8 x 5-1/2 inch (installed in gear case for
shipping)
Bolt, 3/8 x 4-1/2 inch (installed in gear case for
shipping)
Nut, 3/8 inch (installed in case for shipping)
Pulley
Key
Set screw, 5/16 inch
Idler pulley
Spacer
Belt guide
Belt guard
Bolt, 3/8 x 1–5/8 inch
Lock nut, 3/8 inch
1
1
1
1
2
1
1
2
1
1
1
1
1
1
Installing the tiller hitch and pulleys
Rear shield
Cotter pin, 1 inch
Lift chain
Clevis
1
3
1
1
Installing the rear shield and lift chain
To Next Page
Loading...
