8
m-2708
1
2
4
5
6
3
Figure
7
1. Control
cable
2.
Spring cover
3.
Control bar bracket
4. T
op hole
5.
Bottom hole
6.
1/16 to 1/8 in. (0.16 to
0.32 cm) gap
1
2
3
5
m–4017/4012
4
Figure
8
1. Cable
2. Control
bar bracket
3. T
op hole
4.
Bottom hole
5.
1/16 to 1/8 in. (0.16 to
0.32 cm) gap
5. Fully
insert the handle locks.
6. T
ighten the knobs until they are snug.
7.
Ensure that a 1/16 to 1/8 in. (0.16 to 0.32 cm) gap
exists between the control bar and the handle (Refer to
Adjusting the Contr
ol Cable
on page 12).
Before
Starting
Mixing
Gasoline and Oil
Use
only clean, fresh, lead-free gasoline (including
oxygenated or reformulated gasoline) with an octane
rating of 87 or higher
. T
o ensure freshness, purchase only
the amount of gasoline you expect to use in 30 days.
Using unleaded gasoline results in fewer combustion
chamber deposits and longer spark plug life.
IMPORTANT
: Do not use methanol, gasoline
containing methanol, gasohol containing mor
e than
10% ethanol, pr
emium gasoline, or white gas. Using
these fuels can damage the engine’
s fuel system.
IMPORTANT
: Do not use automotive oil (i.e., SAE 30,
10W30, etc.), a two-cycle oil that is not NMMA- or
TCW
-certified, or a fuel mixed at the wr
ong
gasoline/oil ratio. This can cause engine damage not
cover
ed under the T
or
o warranty
.
To Next Page
Loading...
Need help?
General
