9
Setup
Note: Determine the left and right side of the machine from the normal operating position.
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
DESCRIPTION QTY. USE
Speed selector lever assembly 1 Install the speed selector lever
Key 2 Start engine
Hydraulic oil filter 1 Break-in oil change
Drain hose 1 Drain the engine oil
Installing the Valve Lever
1. Remove and discard the nut securing the bolt and
washer to the speed selector lever.
2. Secure the lever to the speed selector valve using the
bolt and washer as illustrated in Figure 2.
2
m–8204
1
Figure 2
1. Speed selector lever 2. Speed selector valve
Charging the Battery
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Warning
Battery terminals or metal tools could short
against metal components, causing sparks. Sparks
can cause the battery gasses to explode, resulting
in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the traction unit.
• Do not allow metal tools to short between the
battery terminals and metal parts of the
traction unit.
Warning
1. Park the traction unit on a level surface, raise the
loader arms, and install the cylinder locks; refer to
Using the Cylinder Locks, page 17.
2. Stop the engine and remove the key.
To Next Page
Loading...
