T roubleshooting
Perform only the steps described in these instructions. All further
inspection, maintenance, and repair work must be performed by an
authorized service center or a similarly qualied specialist if you cannot
solve the problem yourself.
Always remove the battery from the tool when troubleshooting, inspecting,
maintaining, or cleaning the tool.
Problem
Possible Cause Corrective Action
1. The battery is not fully
installed in the tool.
1. Remove and then
replace the battery into
the tool, making sure
that it is fully installed
and latched.
2. The battery pack is not
charged.
2. Remove the battery
pack from the tool and
charge it.
3. The battery pack is over
or under the appropriate
temperature range.
3. Move the battery pack
to a place where it is
dry and the temperature
is between 5°C (41°F)
and 40°C (104°F).
4. There is moisture on
the leads of the battery
pack.
4. Allow the battery pack
to dry or wipe it dry .
5. The battery pack is
damaged.
5. Replace the battery
pack.
The tool does not run or
does not run continuously .
6. There is another
electrical problem with
the tool.
6. Contact an Authorized
Service Dealer .
1. The battery pack charge
capacity is too low .
1. Remove the battery
pack from the tool and
fully charge the battery
pack.
The tool does not reach full
power or the motor housing
is getting hot.
2. The air vents are
blocked.
2. Clean the air vents.
35
To Next Page