Toro GrandStand 74504TE - Adjusting the Deck-Lift Spring

g000975
Figure88
1.Measurefromalevel
surface
2.Measurethebladeatpoint
A
5.Ifthemeasurementisnotcorrect,locatethe
front2yokesonthemachine(Figure87).
6.Loosenthesideboltandjamnutoftheyokes.
7.Adjustthetopboltoftheyokesuntiltheblade
tipsmatch7.6cm(3inches).
8.Tightenthejamnutsandsidebolts.
AdjustingtheDeck-Lift
Spring
Note:Adjustingthecompressionspringaltershow
muchthedeckoatsandtheamountofeffortneeded
toliftthedeckwhenusingtheheight-of-cutlever.
•Morespringcompressionreducestheleverlift
forcerequiredandcausesthedecktooatmore.
•Lessspringcompressionincreasestheleverlift
forcerequiredandcausesthedecktooatless.
1.Raisetheheight-of-cutleverandlockitintothe
transportposition.
2.Checkthedistancebetweenthespringnut
andtherearsideoftheweldedmountbracket
(Figure89).
3.Ensurethatthelengthisbetween47to50mm
(1.8to2inches)(Figure89).
4.Ifneeded,adjustthedistancebyadjustingthe
boltonthefrontofthemountbracket(Figure89).
g031398
Figure89
1.Deck-liftspring
4.Adjustmentbolt
2.Springnut
5.Lengthisbetween47to
50mm(1.8to2inches).
3.Rearsideofthemount
bracket
5.Repeatthisprocedurefortheoppositedeck-lift
spring.
52