Toro Greensmaster
3150 - Page 2

6.Loosenthenutsecuringthehydrauliclinetothe
90-degreettingatfrontofthehydrauliclterhead
(Figure2).
1
2
3
6
5
4
g025799
7
Figure2
1.Hydrauliclterhead
5.Hourmeter
2.Straighttting6.Controlpanel
3.90-degreettingwithnut
7.Hoseclamp
4.Filterheadspacer
7.Unplugthewireharnessconnectorfromthehour
meterterminals(Figure2).
8.Removethe2setsofscrews,washersandspacers
securinghydrauliclterheadtoundersideofthe
controlpanel(Figure2).
Note:Retainthescrews,washersandthespacerfor
re-assembly.
9.Removethescrewsecuringthefusebrackettothe
controlpanel.Movethebracketoutoftheway.
Note:Retainthescrewforre-assembly.
10.Removethe4screwssecuringthecontrolpaneltothe
tractionunitframe.
11.Movethelterheadforwardallowingtheremovalof
thehoseandclampfromthestraightttingonthe
lterhead(Figure2).
Note:Discardthettingandclamp.
12.Ontheotherendofthehose,removetheclampand
thestraightttingfromthehydraulicreservoir(Figure
3).
Note:Retaintheclampbutdiscardthehoseand
tting.
4
2
g025800
1
3
Figure3
1.Hoseclamp
3.O-ring
2.Straighttting
4.Hydraulicreservoir
13.Installthe90-degreettingwiththeO-ringintorearof
lterhead(Figure4).
Note:Positionthettingsoitpointsstraightdown.
Note:Makesurethattheo-ringsareinplacewhen
installingthettings.
1
1
g025801
Figure4
1.90-degreetting
14.Thefollowingstepsonlyneedtobeperformedon
tractionunitswithaserialnumberintherangeof
220000001through220999999.
Note:Proceedtostep15iftheserialnumberisnot
inthisrange.
•Removethe3setsofscrews,washersandspacers
securingthehydraulicreservoirtothetractionunit
frame.Slidethereservoirrearward.
•Thefueltankmountingscrewsmayhavetobe
loosenedtoslidethereservoirrearward.
•Togainadditionalclearancewheninstallingthe
ttingintoreservoir,liftfrontofthereservoir.
2