Toro Groundsmaster 120 - Maintenance; Recommended Maintenance Schedule

19
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After first 5 Hours • Oil—change
Each Use
• Oil—check level
• Safety System—check
• Brake—check
• Engine—clean outside and cooling fins
5 hours • Brake—check
25 hours
• Bearings and Bushings—grease
1
• Foam Air Cleaner—clean
1
• Paper Air Cleaner—clean
1
50 hours
• Oil—change
1
• Belts—check for wear/cracks
• Tires—check pressure
• Battery—check electrolyte level
100 hours
• Oil Filter—change
1
(Every other oil change)
• Engine—clean outside and cooling fins
• Paper Air Cleaner—replace
1
• Fuel Filter—replace
200 hours • Spark Plug(s)—check
250 hours
• Hydraulic System—change oil
• Hydraulic System—change filter
500 hours • Front Axle—change oil
At Storage
• Chipped Surfaces—paint
• Perform all maintenance procedures listed above before storage
1
More often in dusty, dirty conditions
Important Refer to your engine operator’s manual for additional maintenance procedures.
Caution
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug(s) before you do
any maintenance. Set the wire aside so that it does not accidentally contact the spark plug.