Specifications
Width of Cut: 62 in.
Height–of–Cut: Adjustable from 1–1/2” to 4–1/2” in 1/2”
increments.
Cutter Housing: 4” deep housing is made of 12
gauge
steel and reinforced with 10 gauge channel and plates.
Cutting Unit Drive: Isolation mounted gear box on cut-
ting unit is driven by PTO shaft. Power is transmitted to
the blades by one hex ”AA” section belt. Spindle shafts
are 1 inch diameter and supported by two greaseable,
tapered roller bearings.
Cutting Unit Blades: Three 21–3/4” long and 1/4”
thick
heat treated steel, Recycler blades .
Castor Wheels: Front and rear castor wheels have 8 in.
x 3.50 in. hard rubber tires and roller bearings.
Cutting Unit Lift: Independent lift arms and hydraulic
weight transfer provide deck flotation.
Weight: 340 lb.
Specifications and design subject to change without notice.
Guardian 62 Recycler Cutting Unit
Page 15 – 2
Rev. B
Groundsmaster 223–D
To Next Page
Loading...
