Toro Groundsmaster 4000-D - Page 25

Figure21
8.Removethehairpincottersandclevispinssecuring
thedamperlinkstothecuttingunitbrackets
(Figure22).Alignthedamperlinkholeswiththe
selectedheight-of-cutbracketholesinthecutting
unitframe(Figure23),inserttheclevispins,and
installthehairpincotters.
Important:Thedamperlinklengthshould
neverbeadjusted.Thelengthbetweenthehole
centersshouldbe5-3/8inch(13.7cm).
Figure22
1.Damperlink
Figure23
AdjustingtheSkids
Theskidsshouldbemountedinthelowerposition
whenoperatinginheightofcutsgreaterthan2-1/2
inches(64mm)andinthehigherpositionwhen
operatinginheightofcutslowerthan2-1/2inches(64
mm).
Adjusttheskidsbyremovingtheangeboltandnuts,
positioningthemasdesired,andinstallingthefasteners
(Figure24).
Figure24
1.Skid
AdjustingtheCuttingUnitRollers
Thecuttingunitrollersshouldbemountedinthelower
positionwhenoperatinginheightofcutsgreaterthan
2-1/2inches(64mm)andinthehigherpositionwhen
operatinginheightofcutslowerthan2-1/2inches(64
mm).
1.Removetheboltandnutsecuringthegagewheelto
thecuttingunitbrackets(Figure25).
25