Toro Groundsmaster 4110-D - Page 314

Groundsmaster 4110-- DOperator Cab Page 9 -- 4
Air Conditioning Compressor
1. Cap screw (3 used)
2. Lock washer (8 used)
3. Pulley
4. V--belt
5. Lower radiator hose
6. Hose clamp (2 used)
7. Lower radiator hose
8. Cap screw
9. Alternator plate
10. Carriage screw
11. Flat washer
12. Idler pulley
13. Idler plate bracket
14. Lock nut
15. Cap screw
16. A/C compressor mount
17. Flat washer
18. Cap screw
19. Cap screw
20. Spacer
21. Compressor arm
22. Lock washer (5 used)
23. Hex nut (5 used)
24. Cap screw
25. Hex nut (2 used)
26. Cap screw
27. Flat washer
28. Spacer (2 used)
29. Alternator (90 amp)
30. Air conditioning compressor
31. Alternator wire harness
32. Radiator fitting
33. 90
o
fitting
34. 90
o
fitting
35. Bolt
Figure 1
FRONT
RIGHT
11
2
1
3
18
4
7
8
6
10
9
5
17
16
12
13
14
15
8
2
20
22
21
23
24
26
25
27
28
29
19
30
31
32
33
34
23
22
22
15
23
22
2
17
17
2
35
Removal (Fig. 1)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Raise hood to allow access to engine.
3. Loosen lock nut that secures idler pulley. Move
pulley to loosen A/C compressor drive belt. Remove
drive belt from A/C compressor pulley.
4. Inspectcompressordrivebeltforglazingordamage.
Replace drive belt if necessary.