Groundsmaster 4110-- DOperator Cab Page 9 -- 14
3. Slideairducthoseontoheater/evaporatorassembly
covers and secure with cable tie.
4. Remove capsthatwereplacedonhosesandfittings
during the removal process. Using labels placed during
removal, properly secure hoses to heater core, evapo-
rator and drier--receiver.
5. Make sure that condensation hoses are secured to
bottom housing of heater/evaporator assembly and are
routed to cab frame for proper draining of condensate.
6. Connect wire harness connectors to fan motor and
binary switch on drier--receiver.
7. Make sure that all machine air conditioning compo-
nents are installed and secure.
8. Have a certified air conditioning service technician
evacuate the air conditioning system completely, prop-
erly recharge the system with R134a refrigerant and
then leak test the system. A/C system capacity is
approximately1pound 6 ounces (624 gm) of R134a re-
frigerant.
9. Operate the heater system to make sure that no en-
gine coolant leaks exist.
10.Lower and secure roof assembly (see Roof Assem-
bly Installation in this section).
To Next Page
Loading...
