Maintenance
30
Maintenance Procedure Maintenance Interval & Service
✝Initial break in at 10 hours
‡Initial break in at 50 hours
‡Change Planetary Gear Drive Fluid
Check Rear Wheel Toe In
Maintenance Schedule
Change Brake Fluid
Change Fuel Filter
Change Thermostat
Replace Safety Switches
Flush Cooling System and Replace Hoses
Fuel Tank- Drain/Flush
Change Hydraulic Oil
Check Battery Level/Cable Connections
‡Replace Hydraulic Filter
‡Torque Head and Adjust Valves
‡Check Engine RPM (idle and full throttle)
Service Air Filter
Replace Fuel/Water Separator Filter
✝Torque Wheel Lug Nuts
‡Change Engine Oil and Replace Filter
✝Check Fan and Alternator Belt Tension
Inspect Cooling System Hoses
Lubricate All Grease Fittings
Inspect Air Filter, Dust Cup, and Baffle
Clean Under Cutting Unit Belt Covers
Check Cutting Unit Drive Belt
Adjustment
Every
800
hours
Every
400
hours
Every
200
hours
Every
100
hours
Every
50
hours
Recommendations
Items are recommended every 1000 hours
or 2 years, whichever occurs first.
To Next Page
Loading...
