Need help?Do you have a question about the Toro Groundsmaster 5910 and is the answer not in the manual?
General| Transmission | Hydrostatic |
|---|---|
| Deck Lift | Hydraulic |
| Fuel Tank Capacity | 33.5 gallons |
| Turning Radius | 18 inches |
| Standard Tires | Front: 26x12-12 |
| Ground Speed | 0 - 10 mph |
| Speed Range | 0 - 10 mph |
Essential safety guidelines for operating the machine safely and avoiding injury.
Identification and explanation of safety decals located on the machine for hazard awareness.
Critical safety checks and precautions to perform before starting the machine.
Guidelines for safe handling, storage, and use of diesel fuel.
Procedure for setting the desired cutting height for optimal grass cutting.
Essential safety guidelines for operating the machine.
Safety procedures for rollover protection and operating on slopes.
Explanation of the DPF regeneration process and its importance.
Procedure for initiating a reset regeneration process.
Ensuring machine is ready for parked or recovery regeneration.
Steps to start and complete parked or recovery regeneration.
Adjusting cutting height and mower-deck pitch for optimal cut.
Safety procedures to follow after the machine has finished operation.
Critical safety precautions to follow before and during maintenance.
Schedule outlining routine maintenance tasks and intervals.
Crucial safety guidelines for engine maintenance procedures.
Instructions for checking and servicing the engine's air cleaner.
Procedure for checking the engine oil level daily.
Scheduled procedure for replacing engine oil and oil filter.
Servicing the Diesel-Oxidation Catalyst (DOC) and Soot Filter.
Safety precautions for working on the electrical system.
Procedure for jump-starting the machine's battery.
Safety precautions for working with the cooling system.
Procedure for flushing and replacing engine coolant.
Procedure for inspecting and replacing blade-drive belts.
Critical safety precautions for working with hydraulic systems.
Procedure for checking the hydraulic fluid level.
Procedure for draining and refilling the hydraulic fluid.
Critical safety guidelines for inspecting and servicing blades.
Procedure to check blades for bends after striking an object.
Procedure for inspecting cutting edges and sharpening blades.
Safety guidelines for storing the machine and fuel safely.
To Next Page
