Toro Groundsmaster 5910 - Removing the Batteries

1.Parkthemachineonalevelsurface,engagethe
parkingbrake,lowerthecuttingdeck,andshut
offtheengine.
2.Sitintheoperatorseatandhavetheother
personmaketheconnections.
Note:Ensurethatthejumperbatteryisa12V
battery.
Important:Ifyouareusinganothermachine
forpower,ensurethatthe2machinesare
nottouchingeachother.
3.Removethecoversfromthejumpposts(Figure
107).
4.Connectthepositive(+)jumpercabletothe
positivejumppost(Figure109).
g033269
Figure109
1.Positive(+)jumppost3.Negative(-)jumper-cable
clamp
2.Negative(-)jumppost4.Positive(+)jumper-cable
clamp
5.Connectthenegative(-)jumpercabletothe
negativejumppost(Figure109).
6.Starttheengine.
Important:Iftheenginestartsandthen
stops,donotoperatethestartermotoruntil
thestartermotorstopsturning.Donot
operatethestartermotorformorethan30
secondsatonetime.Wait30secondsbefore
operatingthestartermotortocoolthemotor.
7.Whentheenginestarts,havetheotherperson
disconnectthenegative(-)jumpercablefrom
thenegativejumppostandthendisconnectthe
positive(+)jumpercable(Figure109).
RemovingtheBatteries
1.Openthehoodandturnthebattery-disconnect
switchtotheOFFposition.
2.Removethethree3angescrewsfromeach
sideoftherearbumperasshowninFigure110.
3.Loosentheremainingangescrewssecuring
therearbumpertotheframeandpivotthe
bumperdownward.
g199824
Figure110
1.Rearbumper
3.Removethese3ange
screwsonbothsides.
2.Loosenthisangescrew
onbothsides.
4.Loosentheknobsandremovebothsideshrouds
(Figure111).
g199825
Figure111
1.Knobs2.Removethesideshrouds
onbothsides
5.Removethe6angescrewssecuringrear
shroudtotheframeandremovetherearshroud
(Figure112).
77