Toro GT Classic 73450 - Using the Lights; Installing PTO Belt

21
m-4982
1
Figure 18
1. Adjustment knob
Using the Lights
The headlights are turned on with a separate position,
lights, of the ignition switch (Fig. 19). The lights are on
while the ignition switch is in the lights position even with
the engine off. Remove the key when the machine is left
unattended so lights cannot be turned on discharging the
battery.
m–3382
1
Figure 19
1. Light position
Installing PTO Belt
1. Park the machine on a level surface, disengage the
power take off (PTO), set the parking brake, stop the
engine and remove the key.
2. Remove the belt cover.
3. Unplug the clutch connector (Fig. 20).
4. Pull out the PTO stop out of the clutch (Fig. 20).
5. Rotate the clutch to allow space between the belt guide
and the clutch. This will allow the belt to be installed
onto a clutch pulley (Fig. 20).
6. Place belt into a clutch pulley (Fig. 20).
Note: Install belt in the inside pulley groove for mowers
and the outside pulley groove for a tiller or snowthrower.
7. Install the PTO stop back into the clutch (Fig. 20).
8. Install the clutch connector (Fig. 20).
9. Install the belt cover.
m–5539
1
5
2
4
3
Figure 20
1. PTO clutch
2. PTO stop
3. Belt groove
4. Belt guide
5. Clutch connector