Toro GT Classic 73450 - Servicing the Headlights; Servicing the Taillights; Servicing the Battery

30
m–2467
1
Figure 38
1. Full cold level
Servicing the Headlights
Removing the Bulb
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
key.
2. Open the hood. Pull wire connectors off light
terminals.
3. Remove screw securing retainer bracket (Fig. 39).
4. Lift and twist bulb out of pocket (Fig. 39).
1
2
3
4
5
m–2485
Figure 39
1. Bulb
2. Retainer bracket
3. Tabs
4. Screw
5. Terminals
Installing the Bulb
1. Locate index boss horizontal and twist bulb under tabs
on left side of pocket (Fig. 39).
2. Hold bulb in socket with retainer bracket and secure
with screw (Fig. 39).
3. Push wire connectors onto bulb terminals (Fig. 39).
Servicing the Taillights
Removing the Bulb
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
key.
2. Inserting a screwdriver into slot and twist to remove
lens (Fig. 40).
3. Pull bulb out of socket
1
2
4
m–2486
3
Figure 40
1. Lens
2. Slot
3. Bulb
4. Socket
Installing the Bulb
1. Align the bulb base with socket and push into position
(Fig. 40).
2. Align and snap the lens onto the base (Fig. 40).
Servicing the Battery
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Service Interval/Specification
Check the electrolyte level in the battery every five hours.
Always keep the battery clean and fully charged. Use a
paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of four
parts water and one part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.