Toro GT Classic 73450 - Maintenance; Recommended Maintenance Schedule

22
Maintenance
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After First Use • Change oil
Each Use
• Check oil level
• Check safety system
• Check brake
• Clean outside of engine
• Check transaxle fluid
Every 5 Hours • Check battery electrolyte
Every 25 Hours
• Service foam air cleaner
1
• Check tire pressure
Every 50 Hours
• Grease chassis
1
• Check belts for wear/cracks
Every 100 Hours
• Change oil
1
• Replace paper air cleaner
1
• Replace fuel filter
• Check front wheel toe-in
• Clean outside of engine
• Adjust PTO Clutch/Brake adjust
Every 200 Hours
• Change oil filter
1
• Check spark plug(s)
At storage
• Chipped Surfaces—paint
• Perform all maintenance procedures listed above before storage
After Storage
• Check safety system
• Check brake
• Check spark plug(s)
• Check battery electrolyte
• Check tire pressure
1
More often in dusty, dirty conditions
Important Refer to your engine operator’s manual for additional maintenance procedures.
Note: Determine the left and right sides of the machine from the normal operating position.
Caution
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do
any maintenance. Set the wire aside so that it does not accidentally contact the spark plug.