Toro LT3340 - InfoCenter Settings and Protected Menus; Protected Menu Settings

6
InstallingtheSeat
Model31654
Partsneededforthisprocedure:
4
Locknut(8mm)
4
Hex-headbolt(8x25mm)
Procedure
1.Atthebottomplateofthenewseat,locatethe
seat-mountingholesforyourmachine(Figure
22).
g036928
Figure22
2.Assemblethe4hex-headbolts(8x25mm)
totheholesintheangeofthebottomplate
(Figure23)thatyouidentiedinstep1.
g345847
Figure23
1.Hex-headbolt(8x25mm)2.Flange(seat-bottomplate)
3.Alignthe4hex-headbolts(8x25mm)ofthe
newseatwiththeholesintheoperatorsplatform
(Figure24).
g345846
Figure24
1.Hex-headbolt(8x25mm)3.Locknuts(8mm)
2.Operator’splatform
4.Assemble2locknuts(8mm)totheboltsonthe
leftsideoftheseat.
5.Partiallyraisetheoperator’splatformtoaccess
thethreadsofthe2otherhex-headbolts(8x
25mm).
Important:Supporttheseattopreventit
fromfalling.
6.Assemblethe2locknuts(8mm)totheother2
hex-headbolts(8x25mm)byhand.
7.Fullyraisetheplatform.
8.Torquethehex-headbolts(8x25mm)and
locknuts(8mm)to27N∙m(20ft-lb).
16