Toro MH-400 - Operating the Hydraulic Power Pack; Electric Brakes Operation

Page 30 Operating Instructions
Application
Application
Factor
Spinner
Speed
Floor
Control
Rear Gate
Base
Setting
Disc
Setting
Application Spread
Width
Ultra Light 1 10 Maximum 25mm (1”) 1 A 12.2m (40’)
Light 3 10 Maximum 76mm (3”) 1 B 12.2m (40’)
Medium 5 4 Maximum 76mm (3”) 2 B 6.7m (22’)
Medium
Heavy
10 3 Maximum 76mm (3”) 3 B 3.4m (11’)
Heavy 17 3 Maximum 127mm (5”) 3 B 3.4m (11’)
Note: Tractor must be operated at an RPM that will achieve recommended hydraulic flow and pressure
Ground speed of 5-8 km/h (3-5 mph)
MH 400 EH Twin Spinner Suggested Application Guide
Application lb/1000ft
2
kg/100m
2
Spinner
Speed
Floor
Speed
Rear
Gate
Base
Setting
Blade
Setting
Spread
Width
Rear
Elevation
Ground
Speed
Ultra Light 84 4 10 10 25 mm (1”) 1 A 10.7 m (35’) 89 mm (3.5”) 5.5 kph (3.4 mph)
Light 136 7 10 10 76 mm (3”) 1 B 9.1 m (30’) 89 mm (3.5”) 5.5 kph (3.4 mph)
Medium 159 8 5 10 76 mm (3”) 2 B 8.2 m (27’) 89 mm (3.5”) 5.5 kph (3.4 mph)
Medium
Heavy
305 15 4 10 102 mm (4”) 2 B 7.0 m (23’) 89 mm (3.5”) 5.5 kph (3.4 mph)
Heavy 982 48 1 10 127 mm (5”) 3 B 3.4 m (11’) 89 mm (3.5”) 5.5 kph (3.4 mph)
Ultra Heavy 2126 104 1 10 127 mm (5”) 3 B 3.0 m (10’) 0 3.5 kph (2.2 mph)
Note: Work Vehicle must be operated at an RPM that will achieve recommended hydraulic flow and pressure
Ground speed determined using John Deere 5300 Tractor in gears B1 and B3
Information provided based on a sand density of 90 lbs/ft
3