Toro MH-400 - Page 6

Page iv Table of Contents
Figure 15: Control Pendant For EH Models............................................................24
Figure 16: Open rear gate / close rear gate, side view...........................................27
Figure 17: Raise the MH-400 to unload into a smaller machine.............................28
Figure 18: Positioning the Pendant Swing Arm.......................................................28
Figure 19: Twin Spinner Disc Settings....................................................................31
Figure 20: Twin Spinner Base Settings...................................................................31
Figure 21: Cross conveyor positions without swivel kit...........................................32
Figure 22: Cross conveyor positions with swivel kit................................................33
Figure 23: MH Processor, rear view........................................................................33
Figure 24: Option Caddy .........................................................................................34
Figure 25: Option Caddy Control Components.......................................................34
Figure 26: Option Caddy .........................................................................................35
Figure 27: Cross conveyor on storage stands ........................................................35
Figure 28: Cross conveyor on option caddy............................................................35
Figure 29: Cross conveyor storage stands .............................................................36
Figure 30: Hydraulic cylinder support in place ........................................................37
Figure 31: Track the conveyor belt (top view).........................................................40
Figure 32: Tension the conveyor drive chain (side view).......................................41
Figure 33: Grease points.........................................................................................42
Figure 34: Hydraulic schematic For SH Model........................................................44
Figure 35: Hydraulic schematic For EH Model........................................................45
Figure 36: Electrical schematic For SH Model........................................................46
Figure 37: Electrical schematic For EH Model........................................................47