13
SETUP INSTRUCTIONS
10. Place two (2) Hose Clamps on two (2) 3/4" x
19" Jumper Hoses and connect the two (2) "end"
Turret Bodies to the Double Barb Turret Body.
Space nozzles 20" apart and tighten fasteners
securely. Apply thread sealer and install 90° 3/4"
Hose Barb on the Threaded Turret Body. (See
FIG. 4, page 13)
11. Attach the two (2) Strut Assemblies to the
two (2) adjustable clevises found on each side of
the Main Frame tube with (2) 1/2" x 2" clevis pins
and two (2) 1/8" x 1" cotter pins. (See FIG. 4, page
13)
7. Center and attach the Center Boom Pipe to
the two (2) Center Boom Angle with two (2)
clamps, (2) 3/8" x 1" cap screws, flat washers and
lock nuts. Once mounted the Center Boom Pipe
should be approx. 20" from ground.
8. Loosely attach the Double Barb Turret Body
with the Turret Body Clamp in the approximate
center of the Center Boom Pipe. For the most
uniform spray coverage position all Nozzles level
as shown in FIG. 4.
9. Loosely attach a Single Barb Turret Body with
the Turret Body Clamp to LH end of the Center
Boom Pipe. Loosely attach a threaded Turret
Body with the Turret Body Clamp to RH end of
the Center Boom Pipe.
FIG. 4
8. Jumper Hose
9. Strut ASM
10. Adjustable Clevis
11. Turret Body Clamp
12. Threaded Barb Turret
13. 90° Hose Barb
1800
1. Center Boom Angle
2. Main Frame
3. U-bolt
4. Center Boom Pipe
5. Boom Clamp
6. Double Barb Turret
7. Single Barb Turret
1. Extension Boom Pipe
2. Pivot ASM
FIG. 5
3. Boom Support ASM
4. Height Adjustment
1. Boom Support ASM
2. Extension Boom Pipe
3. U-bolt
4. Double Barb Turret
FIG. 6
5. Single Barb Turret
6. Jumper Hose 3/4" x 19"
7. Boom Cap
8. Jumper Hose 3/4" x 21"
12. Insert the plugged end of an Extension Boom
Pipe into the Pivot Assembly and secure with four
(4) 1/4" x 1-1/4" cap screws and lock nuts (See
FIG. 5). Repeat on the opposite side to assemble
the other Extension Boom.
NOTE: If the optional "Foam Marker Kit" is to
be installed, refer to the instructions furnished
with that kit before proceeding to Step 12.
IMPORTANT! DO NOT over-tighten the nuts
in Steps 12 and 14. The clamping action could
crush the Boom Pipe.
1078
To Next Page
Loading...
