EasyManua.ls Logo

Toro Spray Master Series - User Manual

Toro Spray Master Series
88 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FormNo.3439-104RevA
46inand52inSprayer
SprayMaster
ModelNo.34233—SerialNo.406912824andUp
ModelNo.34235—SerialNo.407088124andUp
ModelNo.34237—SerialNo.400000000andUp
Registeratwww.Toro.com.
OriginalInstructions(EN)
*3439-104*A

Table of Contents

Questions and Answers

  • D
    Donna SandovalAug 15, 2025
    Why is there no spray from the Toro Spray Master Paint Sprayer nozzles or poor output?
    • R
      Rachel LuceroAug 15, 2025
      If there's no spray or poor output from the sprayer nozzles, several issues could be the cause. The sprayer tank might be empty, so refill it. The tank shutoff valve(s) may be closed or partially closed; fully open them. The strainer, pump, or nozzles could be clogged or damaged, requiring cleaning, repair, or replacement. Check the hoses for clogs, kinks, or damage, and address as needed. Ensure the boom spray-control valves are in the ON position. Adjust the sprayer pressure and ground speed. Verify the chemical mixture is correct per the manufacturer's recommendations. Finally, inspect the sprayer system for leaks or air drawing, and repair or replace components as necessary.
  • S
    Sarah BoyerAug 18, 2025
    What to do if the Toro Spray Master engine does not start?
    • T
      tinagonzalezAug 18, 2025
      If the engine doesn't start, starts hard, or fails to keep running, check these potential causes: Ensure the fuel tank is filled with fuel. Adjust the throttle lever midway between the SLOW and FAST positions, and set the choke to ON for a cold engine or OFF for a warm engine. If there is dirt in fuel filter, replace the fuel filter. Clean the foam-filter element or replace the paper-filter element if the air filter elements are dirty. Check the electrical connections for good contact and clean them. Clean, adjust, or replace the spark plug if it is worn or damaged. Check the spark-plug wire connection at the spark plug.
  • K
    Kristin JacksonAug 21, 2025
    Why Toro Spray Master engine loses power?
    • X
      xwilkinsonAug 21, 2025
      The engine may lose power due to several reasons. If the engine load is excessive, reduce the ground speed of the machine. If the air-filter elements are dirty, clean the foam-filter element or replace the paper-filter element. If the oil level in the engine is low, add oil to the proper level. Make sure that the cooling fins and air passages for the engine are not plugged with dirt or debris, clean them if needed. Clean or replace the fuel cap if the vent hole in the fuel cap is plugged. If there is dirt in the fuel filter, replace it.
  • P
    Peter SheltonAug 25, 2025
    What to do if Toro Paint Sprayer impeller does not rotate?
    • J
      jeanne52Aug 25, 2025
      If the impeller isn't rotating, start by cleaning any debris buildup. Ensure the hopper screen is clean. If the impeller motor is loose or damaged, repair or replace it. Check the hydraulic hoses and connections if the motor hydraulics are damaged. Set the Impeller-speed control to the ON position and adjust the impeller speed. Replace the drive pin if it is missing. If the bearings failed in the impeller motor, replace the bearings in the motor or the motor assembly.
  • M
    Michael StarkAug 27, 2025
    Why Toro Spray Master engine overheats?
    • B
      Brett WilsonAug 27, 2025
      The engine may overheat if the engine load is excessive, so reduce the ground speed of the machine. If the oil level in the engine is low, add oil to the proper oil level. If the cooling fins and air passages for the engine are plugged with dirt or debris, clean them.
  • K
    ktaylorAug 30, 2025
    How to fix uneven spreader pattern on Toro Paint Sprayer?
    • M
      Matthew ChristianAug 30, 2025
      An uneven spreader or sprayer pattern can occur for several reasons. The impeller might be dirty or damaged; in this case, clean, repair, or replace it. Adjust the diffuser control. If the sprayer nozzles are clogged, clean or replace them. Clean the hopper screen if it is plugged. Check to see if the agitator pin for the shaft of the impeller motor is present. Adjust the position of the control cable if the diffuser ramp setting is incorrect.
  • A
    Autumn RuizSep 2, 2025
    What to do if Toro Spray Master starter does not rotate the engine?
    • B
      briancolonSep 2, 2025
      If the starter does not rotate the engine, it could be due to several reasons. Charge the battery if it does not have a full charge. Check the electrical connections for good contact, clean the connector terminals, apply dielectric grease, and connect the connectors if there is corrosion or looseness. Replace the open fuse if a fuse is open.
  • T
    Tom HouseSep 5, 2025
    Why Toro Spray Master machine pulls to the left or right?
    • S
      samuelwallsSep 5, 2025
      If the machine pulls to the left or right, adjust air pressure in the drive tires. Replace motion-control linkage if it is damaged. Repair or replace the front wheel axles if they are bent or damaged. Adjust the motion control tracking.
  • M
    Matthew BarrettSep 8, 2025
    What to do if Toro Paint Sprayer machine does not drive?
    • J
      Judy WalkerSep 8, 2025
      If the machine does not drive, ensure the drive release valves are fully closed. Tension the belt or replace it if it is loose or broken.
  • H
    huynhandrewSep 12, 2025
    What to do if Toro Spray Master Paint Sprayer spray wand does not work?
    • C
      Christopher FosterSep 12, 2025
      If the spray wand doesn't work, start by filling the sprayer tank. Rotate the pressure control to the OPEN position. Clean, repair, or replace the wand if it is clogged or damaged. Clean or replace the nozzle if the spray nozzle for the wand is clogged. Press the trigger. Clean, repair, or replace the hoses if they are clogged or damaged. Connect the hose to the wand, if it is not connected. Straighten the kink in the hose, if the hose for the wand is kinked.

Summary

Safety

Safety-Alert Symbol

Explanation of the safety-alert symbol and its meaning.

General Safety

Important safety precautions for operating the machine.

Safety and Instructional Decals

Controls

Operation

Pre-Operation Safety

Crucial safety checks and considerations before starting operation.

Chemical and Fuel Safety

Operation Safety and Procedures

Safety and operational steps during machine use, including slopes.

Machine Operation

Spreader Operation

Sprayer Operation

Post-Operation Safety

Transporting the Machine

Loading and Securing Machine

Maintenance

Maintenance Safety

Critical safety rules to follow during maintenance.

Recommended Maintenance Schedule

A schedule of maintenance tasks and their service intervals.

Pre-Maintenance Procedures

Component Maintenance

Engine Maintenance

Procedures for servicing the engine's air cleaner, oil, and spark plug.

Fuel System Maintenance

Electrical System Maintenance

Procedures for servicing the battery and fuses.

Drive System Maintenance

Brake and Belt Maintenance

Controls System Maintenance

Hydraulic System Maintenance

Procedures for checking and maintaining hydraulic fluid.

Troubleshooting

The Charging System

Testing Alternator Components

Machine Troubleshooting

Lists common engine, spreader, and sprayer problems and solutions.

Sprayer Issues

Toro Spray Master Series Specifications

General IconGeneral
BrandToro
ModelSpray Master Series
CategoryPaint Sprayer
LanguageEnglish

Related product manuals