Why is the monitor on my Toro 41229 operating erratically?
If the monitor is operating erratically, a two-way radio may be too close to the monitor or its cables. Keep two-way radios away from the monitor and its cables.
How to fix inaccurate area readings on my Toro 41229?
If the area measurement is inaccurate, the sprayer width may not be entered correctly. Check and set the appropriate width in the calibration mode. Also, ensure that the speed sensor is correctly calibrated by calibrating the speed sensor.
What to do if the total volume is inaccurate on my Toro 41229 Paint Sprayer?
If the total volume displayed is inaccurate, it might be because the flow meter is dirty or clogged, so you should clean the flow meter. Another possible cause is that the flow meter isn't calibrated correctly, so you should calibrate the flow meter.
How do I correct an inaccurate distance measurement on my Toro Paint Sprayer?
If the distance measurement is inaccurate, calibrate the speed sensor, as it may not be calibrated correctly.
What should I do if the displayed measurements on my Toro 41229 don't make sense?
If the displayed measurements don't make sense, check the Units of Measurement to ensure it is set correctly. The Units of Measurement may be set to a system other than what you expect.
What to do if a boom section does not turn off on my Toro Paint Sprayer?
If a boom section won't turn off, the valve might be damaged. Stop the spray system and pump, then turn off the sprayer. Remove the retainer from under the boom valve and pull out the motor and stem. Inspect all parts, replacing any that appear damaged.
Why is my Toro Paint Sprayer boom section not spraying?
Several issues can cause a boom section not to spray. It could be due to: * A dirty or disconnected electrical connection on the boom valve: Manually turn off the valve, disconnect the electrical connector, clean all leads, and reconnect it. * A blown fuse: Check the fuses and replace them if needed. * A pinched hose: Repair or replace the hose. * An improperly adjusted boom by-pass valve: Adjust the boom by-pass valves.
Why does my Toro Paint Sprayer speed read 0 or show erratic readings?
A speed reading of 0 or erratic readings may be due to a loose monitor cable; connect the monitor cable securely. It could also mean that the speed sensor is not calibrated correctly; in this case, calibrate the speed sensor.
Why does a pressure drop occur when I turn on a boom on my Toro 41229?
If you experience a pressure drop when turning on a boom on your Toro Paint Sprayer, the boom bypass valve may be improperly adjusted; in this case, adjust the boom bypass valve. Also, there might be an obstruction in the boom valve body; remove the inlet and outlet connections to the boom valve and remove any obstructions. Finally, check for any missing nozzles and replace them if necessary.
Why is the speed always 0 or erratic on my Toro 41229?
If the speed reading is always 0 or erratic on your Toro Paint Sprayer, ensure the monitor cable is securely connected. If that doesn't solve the issue, calibrate the speed sensor. If problems continue, the speed sensor may be damaged, and you should contact your Authorized Service Dealer.
General| Brand | Toro |
|---|---|
| Model | 41229 |
| Category | Paint Sprayer |
| Language | English |
To Next Page
