EasyManua.ls Logo

Toro 41179 - User Manual

Toro 41179
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FormNo.3362-113RevA
Multi-Pro
®
1250TurfSprayer
ModelNo.41179—SerialNo.290000001andUp
ToregisteryourproductordownloadanOperator'sManualorPartsCatalogatnocharge,gotowww.Toro.com.OriginalInstructions(EN)

Table of Contents

Questions and Answers

  • T
    Teresa HooverAug 31, 2025
    What should I do if a boom section on my Toro Sprayer does not spray?
    • M
      Marissa FinleyAug 31, 2025
      If a boom section on your Toro Sprayer does not spray, the electrical connection on the boom valve might be dirty or disconnected. Turn the valve off manually, disconnect the electrical connector on the valve, clean all leads, and then reconnect it. Also, check the fuses and replace them if necessary. A pinched hose can also cause this issue, so repair or replace the hose. Make sure that a boom by-pass valve is properly adjusted.
  • N
    Nicole HarrisAug 25, 2025
    What to do if Toro 41179 Paint Sprayer distance is inaccurate?
    • T
      Timothy HawkinsAug 25, 2025
      If the distance measurement on your Toro Paint Sprayer is inaccurate, calibrate the speed sensor.
  • T
    Tony KaneSep 23, 2025
    Why does the monitor display 6553.5 in the Application Rate setting on my Toro 41179?
    • J
      john57Sep 23, 2025
      If the monitor displays 6553.5 when in the Application Rate setting on your Toro Paint Sprayer, contact your Authorized Service Dealer, because the monitor is not receiving data from the speed sensor.
  • J
    Jessica MeyersSep 4, 2025
    What to do if Toro 41179 engine cranks, but will not start?
    • L
      Lisa LopezSep 4, 2025
      If your Toro Paint Sprayer engine cranks but doesn't start, the fuel tank may be empty, so fill it with fresh fuel. Also, dirt, water, or stale fuel could be in the fuel system, requiring you to drain and flush the fuel system and add fresh fuel. Check for a clogged fuel line and clean or replace it if necessary. Ensure the spark plug lead is connected, and replace the spark plug if it's damaged or dirty.
  • H
    Heather WilliamsSep 9, 2025
    What to do if Toro 41179 Paint Sprayer displayed measurements do not make sense?
    • C
      Craig FigueroaSep 9, 2025
      If the displayed measurements on your Toro Paint Sprayer do not make sense, check the Units of Measurement to ensure that it is set correctly because the Units of Measurement is set to a system other than what you expect.
  • E
    Emily BurnsSep 2, 2025
    Why is the speed always 0 or erratic on my Toro Sprayer?
    • S
      storresSep 2, 2025
      If the speed is always 0 or erratic on your Toro Sprayer, connect the monitor cable. Also, calibrate the speed sensor.
  • D
    Dennis OwensAug 29, 2025
    What to do if my Toro Sprayer engine cranks but won't start?
    • O
      owilsonAug 29, 2025
      If your Toro Sprayer's engine cranks but doesn't start, the fuel tank might be empty; refill it with fresh fuel. Also, the fuel system might contain dirt, water, or stale fuel, requiring you to drain and flush the system and add fresh fuel. Check for a clogged fuel line and clean or replace it if necessary. Ensure the spark plug lead is connected and replace any damaged or dirty spark plugs.
  • R
    Richard PhillipsSep 12, 2025
    Why will my Toro 41179 engine not idle?
    • W
      William Reed MDSep 12, 2025
      If your Toro Paint Sprayer engine will not idle, here are a few potential causes: * The fuel tank vent may be restricted; replace the fuel cap. * There may be dirt, water, or stale fuel in the fuel system; drain and flush the fuel system and add fresh fuel. * A spark plug may be damaged or broken; replace the spark plug. * If the carburetor idle passages are plugged, the idle speed adjusting screw is incorrectly set, the fuel pump is broken, there is low compression, contact your Authorized Service Dealer. * The air cleaner element may be dirty; clean or replace it.
  • P
    pkerrSep 6, 2025
    Why does my Toro Paint Sprayer abnormal vibration or noise?
    • R
      Robert WilsonSep 7, 2025
      If you notice abnormal vibration or noise in your Toro Paint Sprayer, tighten the engine mounting bolts if they are loose.
  • T
    tmacdonaldAug 27, 2025
    Why is the distance reading inaccurate on my Toro 41179 Paint Sprayer?
    • J
      Jennifer SnowAug 27, 2025
      If the distance measurement is inaccurate on your Toro Paint Sprayer, calibrate the speed sensor.

Toro 41179 Specifications

General IconGeneral
Model41179
Power SourceElectric
Max Pressure3000 PSI
Max Flow Rate0.24 GPM
Hose Length25 ft
Spray Tip IncludedYes
TypeAirless
Nozzle Size0.015 in
Product TypePaint Sprayer

Related product manuals