12
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Note: You will need to purchase RTV silicone sealant before installing this kit.
Contact your Authorized Toro Distributor for information on available accessories. After you install the booms and nozzles
and before using the sprayer for the first time, adjust the boom bypass valves so that the pressure and application rate
remains the same for all booms with one or more booms turned off. Refer to Adjusting the Boom Bypass valves, page 30.
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
Description Qty. Use
Jack stands
Clevis pins
4
4
Preparing the Workman
Cover assembly
Geartooth sensor
Screw, M6 x 1.00 x 12
Spring washer, M6
1
1
1
1
Installing the vehicle speed sensor
Fuse Block
Fuse, 10 amp
Fuse, 30 amp
Screw, #10-24 x 3/4 inch
Washer, 7/32 inch
Locknut, #10-24
Electrical harness
Star washer
Wire ties
Decal
1
1
1
2
2
2
1
1
8
1
Installing the electrical harness
Adapter bracket
Bolt, 1/4 x 3/4 inch
Flange nut, 1/4 inch
Control box mount
Bolt, 5/16 x 1 inch
Lock nut, 5/16 inch
1
4
4
1
4
4
Installing the control box mount
Support bracket assembly
Socket head bolts, 3/8 x 1 inch
Lock nut, 3/8 inch
Prop rod
Nut
Yoke
Clevis pin
Cotter pin
1
2
2
1
1
1
1
1
Installing the prop rod assembly
To Next Page
Loading...
