Toro 41229 - Operation; Think Safety First; Sprayer Controls and Components

24
Operation
This section covers the operation of the spray system only.
See your Workman Operator’s Manual for information on
vehicle operation.
Note: Determine the left and right sides of the machine
from the normal operating position.
Think Safety First
Please carefully read all of the safety instructions and
decals in the safety section of both this manual and your
vehicle manual. Knowing this information could help you
or bystanders avoid injury.
1
2
3
4
56 78
9
10
Figure 30
1. Power switch, Spray Pro
monitor
2. Spray Pro monitor
3. Application rate switch
4. Rate lockout key switch
5. Master boom switch
6. Left boom switch
7. Center boom switch
8. Right boom switch
9. Left boom lift switch
10. Right boom lift switch
Sprayer Controls and
Components
Spray Pro
E
Monitor Power Switch
The Spray Pro monitor power switch is the On/Off switch
for the monitor. Press the switch to enable or disable the
Spray Pro monitor (Fig. 30). When the switch is turned
on, a light on the switch illuminates. See the Spray Pro
Monitor section on page 27 for information on operating
the monitor.
Important The Spray Pro monitor switch has power
supplied to it at all times. Make sure the switch is turned
off when stored.
Master Boom Switch
The master boom switch allows you to start or stop the
spray operation. Press the switch to enable or disable the
spray system (Fig. 30). When the master switch is off, the
Spray Pro screen reads “Hold.”
Boom Switches
The boom switches are located along the bottom of the
control panel (Fig. 30). Toggle each switch upward to turn
the corresponding boom section on and downward to turn
them off. When the switch is turned on, a light on the
switch illuminates. These switches will only affect the
spray system when the master boom switch is on.