EasyManua.ls Logo

Toro 41229 - Installing the Electrical Harness; Fuse Block; Fuse, 10 Amp; Fuse, 30 Amp

Toro 41229
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
3. Install the new cover assembly to the transaxle using
the four bolts removed in step 1 (Fig. 5). The correct
orientation of the cover will have the seal facing up
and positioned toward the left hand side of the vehicle.
m–7150
4
2
3
1
5
6
Figure 5
1. Cover
2. Screw, M6 x 1.00 x 12
3. Spring washer, M6
4. Geartooth sensor
5. Seal
6. Front of vehicle
4. Install the geartooth sensor using the screw
(M6 x 1.00 x 12) and spring washer (M6) as shown in
figure 5.
5. Install the PTO kit. Refer the Installation Instructions
for more information.
Installing the Electrical
Harness
1. Remove the screws holding the front hood to the
frame. Remove the hood to access the electrical
wiring.
2. Locate the electrical harness and fuse block in loose
parts.
3. Wire the electrical harness to the fuse block by joining
the wires in the harness to the corresponding wire
connectors in the back of the fuse block (Fig. 6).
4. Connect the black ground wire to the existing 1/4 inch
bolt on the vehicle frame, using the star washer
(Fig. 7).
5. Locate an open red power wire coming from the
existing fuse block. Connect it to the matching red
power wire coming from the new fuse block.
6. Install the fuse block and harness to the frame along
side the existing fuse block, using the two screws
(#10-24 x 3/4 inch), two washers (7/32 inch), and two
locknuts (#10-24) as shown in figure 7.
m–7218
1
3
4
5
10
7
8
9
6
2
Figure 6
1. Wiring harness
2. New fuse block
3. Red/black wire
4. Red/white wire
5. Red wire
6. Black ground wire
7. Foam marker fuse slot
8. Boom lift fuse slot
9. Spray system fuse slot
10. Open slot, not used
7. Install the 10 amp fuse to the spray system fuse slot
and attach new fuse block decal (Fig. 7).
8. Install the 30 amp fuse to the boom system fuse slot
(Fig. 7).
m–7151
1
2
6
7
34
5
8
9
10
Figure 7
1. Fuse block
2. Fuse, 10 amp
3. Screws, #10-24 x 3/4 inch
4. Washers, 7/32 inch
5. Lock nut, #10-24 inch)
6. Existing decal
7. New fuse block decal
8. Ground wire, black
9. Star washer and bolt
10. Fuse, 30 amp

Table of Contents

Related product manuals