29
The Multi Pro
®
1200 is equipped with a Neutral
Switch. The purpose of this switch is to insure
that the vehicle will not start and the Accelerator
Lock will not engage unless the Range Selector
is in the NEUTRAL position.
The Neutral Switch is located underneath the
Shifter Boot and is accessed by removing the Air
Cleaner Cover.
The Neutral Start mechanism is designed to
enable the engine start circuit and Accelerator
Lock circuit only when the Range Selector is in
Neutral. Proper adjustment of the Neutral Switch
must be maintained to ensure this condition.
To adjust the Neutral Switch, follow the steps
below:
1. Place the Range Selector in Neutral, stop
engine and remove key from the ignition.
NEUTRAL SWITCH:
MAINTENANCE
JACKING VEHICLE:
1. Do not start engine while vehicle is on jack
because engine vibration or wheel movement
could cause vehicle to slip off jack.
2. Do not work under vehicle without jack
stands supporting it. The vehicle could slip off
the jack injuring anyone beneath it.
3. The jacking points at the front of the vehicle
are under the A-arms. (Fig. 1)
4. The rear jacking points are on the rear-most
frame support between the angle welds. (Fig. 2)
5. Always chock or block wheels opposite the
side which is being jacked.
FIG. 1
1. Front Jacking Points
FIG. 2
1. Rear Jacking Points
1799
WARNING
If the engine can be started or the
Neutral Accelerator Lock can be set
without the Range Selector in the Neutral
Position, the Neutral Switch circuit is
faulty. DO NOT OPERATE THE
VEHICLE!
1. Neutral Switch 3. Jam Nut
2. Solenoid 4. Switch Ball
FIG. 3
1821
1
2
2. Remove Air Cleaner Cover.
3. Remove Shifter Ball and jam nut from the
Range Selector Handle. Remove six (6) Screws
and nuts securing Shift Boot and lift the Boot from
Seat Base. This allows a view of the Neutral
Switch.
3
4
1858-1200
To Next Page
Loading...
