62
RUN/HOLD KEY:
The Spray Pro Monitor should usually be left in
Run Mode while spraying (see Figure 4). SPEED
and APPLICATION RATE wil be active in Run
Mode. Use HOLD mode for calibrating the
sprayer and fine-tuning the FLOWMETER.
OVERFLOW MESSAGE:
If the display message OFL appears during
calibration distance or calibration flow
measurement, it indicates that the readouts
capacity to display information has been
exceeded, and the affected function must be reset
to 0 to continue counting.
1921
OPERATION:
The Spray Pro
monitor features a large easy-to-
read liquid crystal display with lighted display, and
panel lighting for night use. To get a readout of
any of the monitored functions, simply turn the
rotary selector to the desired item. The console
gives a continuous readout of the function
selected until another one is chosen.
EXAMPLES (See FIG. 4):
To display your speed in miles per hour
(kilometers per hour), turn the dial to SPEED.
To measure distance in feet (meters), turn the dial
to CALIBRATION DISTANCE.
To monitor gallons applied per acre (liters per
hectare), turn the dial to APPLICATION RATE.
SPRAY PRO
SET-UP
FIG. 4
TEST SPEED:
Test speed is a built-in ground speed simulator
that is used in performing pre-spraying checks.
When a typical operating speed is entered, Spray
Pro
will respond as if you were actually driving
that speed. It allows you to simulate your spraying
application with plain water, while remaining
stationary, to make certain that all of the
equipment is operating properly and that your
sprayer can actually perform the intended
application.
To enter a test speed, place the console in TEST
SPEED position, enter calibration, and use the
"+" and "-" keys to enter the desired speed. Turn
the Master and Individual Boom Valves on, and
place the Spray Pro in Run Mode to begin
spraying. APPLICATION RATE can be selected
as normally. Test speed is automatically
overridden when real motion is detected by the
speed sensor.
RESETTING COUNTERS:
To reset the CALIBRATION DISTANCE or
CALIBRATION FLOW counter, first put system in
hold. Turn the dial to the appropriate item and
press the RESET key for approximately three
seconds, until the displays read out automatically
returns to zero.
To Next Page
Loading...
