22
VEHICLE CONTROLS
Familiarize yourself with the controls and
recommended operating procedures before
operating the MULTI PRO
®
1250.
1. SPEED LIMITER:
The Speed Limiter allows the operator to establish
a repeatable ground speed and can be used to
establish a speed less than the full speed in a
selected range. The Speed Limiter works in series
with the Accelerator Pedal. When the Accelerator
Pedal is depressed and the desired ground speed
is achieved, then and only then can the Speed
Limiter be utilized.
A. When the Speed Limiter is in the full
upright position, the engine is stopped at its lowest
speed. (See FIG. 1)
E. When the desired speed is achieved, turn
the speed lock at the base of the Speed Limiter
clockwise to lock. Be sure to unlock (turn
counterclockwise) the speed lock dial at the base
of the Speed Limiter before making any
adjustment. (See FIG. 1)
B. When the Speed Limiter is completely
lowered, the engine is stopped at its highest
speed. (See FIG. 2)
C. Coarse adjustment of the Speed Limiter
is achieved by first depressing the button in the
center of the knob, then by raising or lowering
the knob.
FIG. 1
1. Full Upright Position
2. Knob
3. Button
D. Fine adjustment of the Speed Limiter is
achieved by turning the knob until the desired
speed is reached. Turning the knob clockwise
will lower the knob and accelerate the engine.
Likewise, turning the knob counterclockwise will
raise the knob and decelerate the engine.
FIG. 2
1. Completely Lowered Position
1777
1
1776
UNLOCK
DECELERATE
LOCK
31
2
ACCELERATE
To Next Page
Loading...
