Toro 41593 - User Manual

Questions and Answers

M
Michael WhiteSep 6, 2025
What to do if the engine cranks but doesn't start on my Toro Paint Sprayer?
- J
  Jennifer WilliamsSep 6, 2025
  If your Toro Paint Sprayer engine cranks but doesn't start, the fuel tank might be empty; if so, fill it with fresh fuel. Alternatively, there might be dirt, water, or stale fuel in the fuel system, requiring you to drain and flush the system before adding fresh fuel. Another potential issue is a clogged fuel line, which would need cleaning or replacement. For problems with the kill relay or starter switch, contact your Authorized Service Dealer.
T
Tricia GarrettSep 12, 2025
What to do if a boom section doesn't spray on my Toro Paint Sprayer?
- E
  elizabethbartonSep 12, 2025
  If a boom section on your Toro Paint Sprayer does not spray, first turn the valve off manually. Disconnect the electrical connector on the valve and clean all leads, then reconnect it. Check the fuses and replace them as necessary. Repair or replace any pinched hoses. Ensure the boom by-pass valves are properly adjusted. For damaged boom valves or electrical systems, contact your Authorized Service Dealer.
T
tinabushSep 1, 2025
What to do if my Toro Paint Sprayer has abnormal vibration or noise?
- W
  Whitney Grant MDSep 1, 2025
  If there's abnormal vibration or noise, tighten the engine mounting bolts, as they may be loose.
K
kayla58Aug 26, 2025
Why are there leaks at the fittings of my Toro 41593?
- R
  Raymond BrownAug 26, 2025
  Leaks at the fittings of your Toro Paint Sprayer can occur if the fittings are damaged; check for cracks and replace the fitting if necessary. Another cause can be worn thread sealant; if a leak occurs on the threads, disassemble and seal the joint with joint seal compound.
L
Leslie CookAug 27, 2025
How to fix no rinsing or flushing action in my Toro 41593 Paint Sprayer?
- T
  Tiffany VelezAug 27, 2025
  If your Toro Paint Sprayer has no rinsing or flushing action, it could be because the bottle rinse nozzle is plugged or clogged; disassemble the rotary portion of the nozzle from the lower valve assembly and back flush until the nozzle ports are clear of debris. Alternatively, the flush tee might be plugged or clogged; disassemble the flush tee and clean until the nozzle ports are clear of debris.
A
Amber MitchellSep 23, 2025
What causes a boom valve to leak on a Toro Paint Sprayer?
- R
  Ricky NicholsSep 23, 2025
  If a boom valve is leaking on your Toro Paint Sprayer, disassemble the valve and replace the seals using the Valve Repair Kit; contact your Authorized Service Dealer.
J
Jennifer SanchezSep 12, 2025
Why is my Toro Paint Sprayer sluggish or not operating, causing the engine to stall?
- K
  Kenneth BookerSep 13, 2025
  If your Toro Paint Sprayer does not operate or is sluggish because the engine bogs down or stalls, release the parking brake.
C
Charles PenaSep 18, 2025
Why does my Toro Paint Sprayer engine run, but knocks or misses?
- S
  Sandra MedinaSep 18, 2025
  If the Toro Paint Sprayer engine runs but knocks or misses, it could be due to dirt, water, or stale fuel in the fuel system; drain and flush the fuel system and add fresh fuel. Alternatively, there may be loose wires or poor connections; check and tighten wire connections. The engine may also be overheating; see “The engine overheats” section for more information.
C
Christine WilcoxSep 7, 2025
Why is my Toro Paint Sprayer engine losing power?
- J
  Jillian FosterSep 7, 2025
  If your Toro Paint Sprayer engine is losing power, start by checking the crankcase oil level and adjust it to the Full mark. A dirty air cleaner element can also cause this, so replace it if needed. Additionally, ensure that there is no dirt, water, or stale fuel in the fuel system by draining and flushing it, then adding fresh fuel. If the engine is overheating, refer to the Engine Overheats section. Replacing the fuel cap may resolve the issue if the vent hole in the fuel tank vent fitting is plugged. For low compression issues, contact your Authorized Service Dealer.
M
Mark WestSep 18, 2025
How to troubleshoot a Toro Paint Sprayer when the starter does not rotate the engine?
- T
  Tyler MartinezSep 18, 2025
  If your Toro Paint Sprayer's starter does not rotate the engine, check for corroded or loose electrical connections and ensure they have good contact. Also, inspect the fuse to see if it is blown or loose, and correct or replace it if necessary. Check the battery and charge or replace it if discharged. If these steps don't resolve the issue, the starter or starter solenoid may be broken, or internal engine components may be seized, in which case you should contact your Authorized Service Dealer.