What causes a boom valve to leak on a Toro Paint Sprayer?
If a boom valve is leaking on your Toro Paint Sprayer, disassemble the valve and replace the seals using the Valve Repair Kit; contact your Authorized Service Dealer.
Why does my Toro Paint Sprayer engine will not idle?
If the engine won't idle, the fuel tank vent might be restricted, so replace the fuel cap. Another possibility is dirt, water, or stale fuel in the fuel system, so drain and flush the fuel system and add fresh fuel. The air cleaner element may also be dirty, so clean or replace it.
What to do if a boom section of my Toro 41593 does not spray?
If a boom section isn't spraying, start by checking the electrical connection on the boom valve; it might be dirty or disconnected. Turn the valve off manually, disconnect the electrical connector, clean all leads, and then reconnect it. Also, check the fuses and replace them as necessary. Look for a pinched hose and repair or replace it. Ensure the boom by-pass valves are properly adjusted.
What to do if a boom valve is leaking on my Toro Paint Sprayer?
If a boom valve is leaking, stop the spray system and pump, and turn off the sprayer. Disassemble the valve and replace the O-rings, as one may be deteriorated.
Why are there leaks at the fittings of my Toro 41593?
Leaks at the fittings of your Toro Paint Sprayer can occur if the fittings are damaged; check for cracks and replace the fitting if necessary. Another cause can be worn thread sealant; if a leak occurs on the threads, disassemble and seal the joint with joint seal compound.
How to fix no rinsing or flushing action in my Toro 41593 Paint Sprayer?
If your Toro Paint Sprayer has no rinsing or flushing action, it could be because the bottle rinse nozzle is plugged or clogged; disassemble the rotary portion of the nozzle from the lower valve assembly and back flush until the nozzle ports are clear of debris. Alternatively, the flush tee might be plugged or clogged; disassemble the flush tee and clean until the nozzle ports are clear of debris.
Why does my Toro 41593 Paint Sprayer engine lose power?
Several factors can cause the engine to lose power. The crankcase oil level might be incorrect, so fill or drain to the Full mark. The air cleaner element could be dirty, requiring cleaning or replacement. Also, dirt, water, or stale fuel in the fuel system can be a culprit; in this case, drain and flush the fuel system and add fresh fuel. Finally, the vent hole in the fuel tank vent fitting might be plugged, so replace the fuel cap.
What to do if my Toro Paint Sprayer engine overheats?
If your engine is overheating, check a few things. Ensure the crankcase oil level is correct by filling or draining to the Full mark. Reduce the load and use a lower ground speed if you're experiencing excessive loading. Clean the air intake screens with every use. Also, clean the cooling fins and air passages under the engine blower housing and/or the rotating air intake screen regularly.
What to do if my Toro 41593 engine starts but does not keep running?
If your engine starts but doesn't keep running, consider these possibilities: The fuel tank vent may be restricted, so replace the fuel cap. There might be dirt or water in the fuel system, so drain and flush the fuel system and add fresh fuel. The fuel filter could be clogged, requiring replacement. A fuse might be blown or loose, so correct or replace it. Also check and tighten wire connections if they are loose or have poor connections.
What to do if my Toro 41593 Paint Sprayer starter does not crank?
If the starter doesn't crank, begin by checking the electrical connections for good contact, as they may be corroded or loose. Also, check if a fuse is blown or loose and correct or replace it. The battery could be discharged, so charge or replace it.
General| Brand | Toro |
|---|---|
| Model | 41593 |
| Category | Paint Sprayer |
| Language | English |
To Next Page
