Why does my Toro Paint Sprayer engine will not idle?
If the engine won't idle, the fuel tank vent might be restricted, so replace the fuel cap. Another possibility is dirt, water, or stale fuel in the fuel system, so drain and flush the fuel system and add fresh fuel. The air cleaner element may also be dirty, so clean or replace it.
Why is there abnormal vibration or noise in my Toro Paint Sprayer?
If there is abnormal vibration or noise coming from your Toro Paint Sprayer, start by tightening the engine mounting bolts. If the problem persists, contact your Authorized Service Dealer, as there may be an issue with the engine itself.
What to do if my Toro 41593 Paint Sprayer engine cranks but will not start?
If the engine cranks but won't start, first ensure the fuel tank is filled with fresh fuel. If that's not the issue, there might be dirt, water, or stale fuel in the fuel system, so drain and flush the system and add fresh fuel. Additionally, check for a clogged fuel line and clean or replace it if necessary.
Why is my Toro Paint Sprayer sluggish or not operating, causing the engine to stall?
If your Toro Paint Sprayer does not operate or is sluggish because the engine bogs down or stalls, release the parking brake.
What to do if a boom section doesn't spray on my Toro Paint Sprayer?
If a boom section on your Toro Paint Sprayer does not spray, first turn the valve off manually. Disconnect the electrical connector on the valve and clean all leads, then reconnect it. Check the fuses and replace them as necessary. Repair or replace any pinched hoses. Ensure the boom by-pass valves are properly adjusted. For damaged boom valves or electrical systems, contact your Authorized Service Dealer.
What to do if Toro Paint Sprayer engine starts, but does not keep running?
If your Toro Paint Sprayer engine starts but doesn't keep running, it could be due to a restricted fuel tank vent (replace the fuel cap), dirt or water in the fuel system (drain and flush the system, then add fresh fuel), or a clogged fuel filter (replace the fuel filter). Also, check for a blown or loose fuse (correct or replace it) and loose wires or poor connections (check and tighten wire connections). If these steps don't resolve the issue, the fuel pump or cylinder head gasket might be broken, in which case you should contact your Authorized Service Dealer.
What causes a boom valve to leak on a Toro Paint Sprayer?
If a boom valve is leaking on your Toro Paint Sprayer, disassemble the valve and replace the seals using the Valve Repair Kit; contact your Authorized Service Dealer.
How to fix no rinsing or flushing action in my Toro 41593 Paint Sprayer?
If your Toro Paint Sprayer has no rinsing or flushing action, it could be because the bottle rinse nozzle is plugged or clogged; disassemble the rotary portion of the nozzle from the lower valve assembly and back flush until the nozzle ports are clear of debris. Alternatively, the flush tee might be plugged or clogged; disassemble the flush tee and clean until the nozzle ports are clear of debris.
Why are there leaks at the fittings of my Toro 41593?
Leaks at the fittings of your Toro Paint Sprayer can occur if the fittings are damaged; check for cracks and replace the fitting if necessary. Another cause can be worn thread sealant; if a leak occurs on the threads, disassemble and seal the joint with joint seal compound.
What to do if a boom valve is leaking on my Toro Paint Sprayer?
If a boom valve is leaking, stop the spray system and pump, and turn off the sprayer. Disassemble the valve and replace the O-rings, as one may be deteriorated.
General| Brand | Toro |
|---|---|
| Model | 41593 |
| Category | Paint Sprayer |
| Language | English |
To Next Page
