Unloading a Machine from the
T railer
1. Park the trailer on a level surface and move
the line marker on the machine to the storage
position if they are in the extended position; refer
to your machine Operator ’ s Manual .
2. Remove the quick-release pin, pull up on the
lock lever , and remove the J-hook from the front
tie-down point.
3. T urn on the machine and disengage the parking
brake.
4. W alk on the ground while slowly guiding the
machine down the ramp and of f of the trailer
until the front wheel is on the ground.
Important: Ensure that the front wheel stays
in the channel while backing the machine
straight off of the trailer .
5. Shut of f the machine and engage the parking
brake.
6. Remove the storage pins from the front of the
wheel plates.
7. Install the pins to the top of the ramp and wheel
plate to secure the ramps in the raised position
prior to moving the unloaded trailer .
7
To Next Page
Loading...
Need help?
General
