Toro ProCore 648 - Maintenance; Scheduled Maintenance

30
Maintenance
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After first 8 hours
• Hydraulic fluid—check level
• Hydraulic filter—change
• Pump belt—re–tension
• Coring head fasteners–check torque
After first 50 Hours • Engine oil & filter—change
Each Use
• Engine oil—check level
• Safety System—check
• Engine air intake—clean
1
• Belts—check
• Hydraulic fluid—check level
• Tires—check pressure
• Hydraulic lines—check
Every 25 Hours
• Wash and re–oil air precleaner
• Battery—check electrolyte
Every 100 Hours
• Engine oil & filter—change
1
• Primary air cleaner filter– replace
1
• Fuel filter—replace
• Engine cooling system—clean
1
Every 200 Hours
• Hydraulic filter—change
• Spark Plug(s)—check
Every 500 Hours • Spark Plug(s)—replace
Before Storage Service
• Battery–charge, Disconnect cables
• Gasoline—drain
• Chipped Surfaces—paint
• Perform all maintenance procedures listed above before storage
1
More often in dusty, dirty conditions
Important Refer to your engine operator’s manual for additional maintenance procedures.